WE ARE FOCUS ON SAFETY AND SECURITY

In selecting and using web lashings, consideration shall be given to the required
lashing capacity, taking into account the model of use and the nautral of the load
to be secured, The size, shape and weight of the load, together with the intended
method of use, transport enviromment and the nature of the load will affect the
correct selection. For stability reasons free-standing units of the load have to be
secured with a minimum of one pair of web lashings for frictional lashing and two pairs of web lashing for diagonal lashing

Because of different behaviour and elongation under load conditions, different
lashing equipment (e,g lashing chain and web lashings)shall not be used to lash
the same load. consideration shall also be given to ancillary fittings (components)
and lashing devices in the load restraint assembly are compatible with the web
lashing
Release of the web lashing: care should be taken to ensure theat the stability of
the load is independent of the lashing equipment and that the release of the web
lashing shall not cause the load of fall off the vehicle, thus endangering the
personnel, if necessary attach lifting equipment for further transports to the load
before releasing the tensioning device in order to prevent accidental falling and/or
tilting of the load, this applies as well when using tensioning devices which allow
controlled removal
Before attempting to unload a unit of load its web lashings shall be release
so that it can be lifted freely from the load platform
5.Care should be taken that the web lashing is not damaged by the sharp edges of
the load on which it is used a visual inspection before and after each use is
recommended
7.Web lashings shall not be overloaded: only the maximum hand force of 500N
(50daN on the lable:1daN=1kg) shall be applied mechanical aids such as levers,
bar etc. As extentions are not to be used unless the are parts of the tensioning
device
8 web lashings shall never be used when knotted
9.The webbing shall be protected againset friction, abrasion and damage from
loads with sharp edges by suing protective sleeves and/or corner protectors

Lashing resistant to mineral acids but is attached by alkalis solutions of
acids or alkalis which are harmless may becomes sufficiently concentrated
by evaporation to cause damage, take contaminated webbing out of
service at once thoroughly soak them in cold water and dry naturally

Webbing lashings suitable using in -40 C to +120 C, These rangs can be
very in a chemical environment in that case the advice of the manufacturer
or supplier shall be sought

Changing the environmental temperature during transport maybe affect the
forces in the web lashing checks the tension force after entering warm areas

nspection and repair
Web Lashings Labels and bearing identification can be repaired
Webbing lashing contact with chemical products in accidents should be
emover from service and consults with manufacturing before using again
Webbing lashing tears, cuts, deformations resulting from exposure to heat ,
nicks, breaks in load bearing fibre and retaining stitches should be rejected
end fittings and tensioning devices deformations, splits, pronounced signs
of wear, signs of corrosion should be rejected